Barco DML-1200, User Manual

Page: 87 / 113

13. Servicing
Image 13-17
The fi lter is mounted at the back side of this side panel.
3. Remove the HEPA fi lter on the side panel by pulling the spring clamp (A) away from the fi lter and then pivot the fi lter a little (B)
and take it out (C).
AA
B
C
Image 13-18
4. Insert a new HEPA fi lter by pulling the spring clamp away and insert the fi lter into its position. Point the arrow on the side of the
fi lter to outside of the plate. Release the spring clamp.
5. Reinstall the side panel of the base.
13.9 Removal of a lamp unit
W
ARNING
:
This procedure may only be performed by quali fi ed technical service personnel.
C
AUTION
:
Never attempt to disassemble the lamp from its housing or to dispose of it. Due to its high internal
pressure, the lamp may explode in either hot or cold states if improperly handled. For recycling guidelines,
see "Recycling guidelines", page 6.
About the lamps
The device head contains 4 lamps, each of them in a separate lamp house. Each lamp can be individually replaced by a spare lamp.
Each lamp position has a number. That number is also used in the software to identify the parameters of the corresponding lamp.
R59770208 DML-1200 06/11/2009 83