Barco DML-1200, User Manual

Page: 45 / 113

8. Control menu
8.4 Demo mode
What can be done ?
Within the DML-1200 a demo run is programmed. When the demo mode is activated, the demo run starts with an interval of x
seconds. The number of times the demo run has been started is indicated in
Demo cycles .
Practical use of the demo mode : for service purposes to verify the normal operation of the device.
Demo mode can only be started if no DMX data is applied to the device.
How to activate, deactivate the demo
1. Press Enter to start up the main menu.
2. Turn the jog dial to select Control and press Enter .
3. Turn the jog dial to select Demo mode and press Enter .
The selection jumps to ON or OFF.
4. Turn the jog dial to select ON or OFF and press Enter .
ON Demo mode starts
OFF
Demo mode stops
Image 8-5
Image 8-6 Image 8-7
How to set up the delay
1. Press Enter to start up the main menu.
2. Turn the jog dial to select Control and press Enter .
3. Turn the jog dial to select Demo delay and press Enter .
The selection jumps to digit indication.
4. Turn the jog dial until the desired delay is obtained.
The delay is expressed in seconds multiplied by 4.
Image 8-8
Image 8-9 Image 8-10
R59770208 DML-1200 06/11/2009 41