DCS-200 • User’s Guide
85
4. Operation
Using Inputs
•
For information about using the system in conjunction with HDCP inputs, refer to
the “
” section on page 86.
cäáéJÑäçé=jçÇÉ
Whenever you press
TAKE
to mix between inputs (including the
LOGO
), the DCS-200
automatically flip-flops inputs. Two actions occur when
TAKE
is pressed:
•
The blinking “next” source transitions to Program. Once it is fully on Program, the
button lights solid.
•
The previous (solid) source on Program automatically becomes the pending
“next” source, and the button blinks.
Figure 4-60.
Flip-flop mode, before and after TAKE
Repeatedly pressing
TAKE
continues to flip-flop the current and pending sources in this
manner. Please note:
•
If
Black Auto Take
is
OFF
(in the
User Preference Menu
), you must press
TAKE
to transition to black. If a source is pending, the source flip-flops to
Program — after the system is fully in black.
•
If
Black Auto Take
is
ON
, simply press
BLACK
to transition to black. If a source
is pending, it
remains
pending after the transition. There is no flip-flop.
•
If
Key Auto Take
is
OFF
(in the
User Preference Menu
), you must press
TAKE
to transition the key up or down. If a source is pending, you will transition to the
new source and add the key, and the new source flip-flops to Program.
•
If
Key Auto Take
is
ON
, simply press
KEY
to transition the key up or down. If a
source is pending, it
remains
pending after the transition. There is no flip-flop.
Inputs
3
5
6
8
SDI
1
2
4
7
LOGO
Program
(solid)
Pending
(blinking)
Inputs
3
5
6
8
SDI
1
2
4
7
LOGO
Pending
(blinking)
Program
(solid)
Sources before
TAKE
Sources after
TAKE
