DCS-200 • User’s Guide
81
4. Operation
Using the Setup Menu
To clear the message and continue operations, press
ESC
.
aá~ÖåçëíáÅë
From the
System Menu
, select
Diagnostics
to display the
Diagnostics Menu
:
Figure 4-55.
Diagnostics Menu
If you suspect a problem with the DCS-200, press
SEL
to run a series of internal diagnostic
tests. The menu will report back “
PASS
” or “
FAIL
.”
p~îÉ=póëíÉã=pí~íÉ
From the
System Menu
, select
Save Config
to save all current “system” settings so that
they may be restored at power up. A message is briefly shown, after which the DCS-200
returns to the
System Menu
.
Figure 4-56.
Saving System Configuration Message
Please note the following important points regarding the system configuration file:
•
When you perform the
Save Config
function, all configuration parameters from
the
System Menu
are saved in non-volatile memory. If you
do not
perform the
function, data will not be restored upon the next system power up sequence.
•
This command also saves the current
input
as the default power-up selection.
Note
This message is a warning only, which does not prevent the
operation of the DCS-200. If this message appears, it is
recommended that you contact Barco Customer Service.
D I A G N O S T I C S
> S E L = S t a r t T e s t s
Note
If the menu reports “
FAIL
,” contact Barco Customer Service.
In Appendix C, refer to the “
page 160 for contact details.
S a v i n g S y s t e m C o n f i g . . .
Note
If you want the DCS-200 to always power up and acquire an
input other than input
1
, perform the
Save System State
command while the desired input is selected on Program.
