DCS-200 • User’s Guide
57
4. Operation
Using the Setup Menu
_~ÅâÖêçìåÇ
From the
Input Menu
, select
Background
to change the system’s background color
between “
Black
” and “
Gray
.” This is a global setting.
When set to
Gray
, you can clearly see the edges of an input, particularly when the input’s
aspect ratio does not match the output’s aspect ratio. Note that the background selection
persists between source changes.
qáãáåÖ=^Çàìëí
From the
Input Menu
, select
Timing Adjust
to display the
Timing Adjust Menu
, which
allows for exact positioning of the input's active area.
Figure 4-24.
Timing Adjust Menu (sample)
For DVI digital, NTSC and PAL videos the
Timing Adjust
Menu
is informational only.
Because the individual parameters cannot be adjusted, they are bracketed, as shown in the
following illustration.
Timing Adjust Menu — DVI Digital, NTSC, PAL (sample
T I M I N G A D J U S T
> A u t o C o n f i g
S a m p l i n g
[ 1 : 1 ]
P h a s e A
[ 0 ]
P h a s e B
5
H T o t a l
2 1 6 0
H P o s i t i o n
4 9 6
H A c t i v e
1 6 0 0
V T o t a l
[1250]
V P o s i t i o n
4 9
V A c t i v e
1 2 0 0
Note
Timing Adjust Menu
settings apply to
analog input sources
only,
except
for NTSC and PAL sources. For digital, NTSC
and PAL sources, refer to the “
” section on
T I M I N G A D J U S T
> A u t o C o n f i g
S a m p l i n g
[ 1 : 1 ]
P h a s e A
[ 0 ]
P h a s e B
[ N / A ]
H T o t a l
[ 8 5 8 ]
H P o s i t i o n
[ 1 2 3 ]
H A c t i v e
[ 7 2 0 ]
V T o t a l
[ 5 2 5 ]
V P o s i t i o n
[ 3 6 ]
V A c t i v e
[ 4 8 6 ]
