Barco CX-50 Gen2, Installation Manual

Page: 79 / 144

79 R5900120 /01 CX-50 Gen2
Image 6–13 Display setup, output
3. To activate the screen saver, drag the slider bar to the left or to the right until the desired delay time is
reached.
When the slider is set completely to the left, the screen saver will never be activated.
6.8 Display setup, Inputs
Input mode setup
1. Log in to the Configurator .
2. Click Display & Audio → Inputs
Image 6–14 Display, Inputs
3. To change the input mode, click on the drop down next to Input Mode and select the desired option.
The following option are possible:
• Wired RoomDock: display screen will be displayed on local device.
• DisplayPort over USB-C: input from HDMI device via convertor to DisplayPort over USB-C
• Off: no input allowed
When there is a signal available, the led next to Signal lits up green.
4. Enter a source name. Click in the input field, select the current name and enter a new name.
5. Click Save Settings .
CX-50 Gen2 Configurator