Barco Coronis Uniti, User Manual

Page: 14 / 70

K5902079 /11 Coronis Uniti 14
CAUTION: Do not try to pivot your display when attached to the stand. Trying to do so could cause
serious damage to your display and its stand.
2.3 Cable connections
To connect the cables
1. Remove the connector cover.
2. Connect the DisplayPort inputs with the DisplayPort outputs on the workstation.
Note: To obtain full resolution and full refresh rate, two DisplayPort video input cables must be connected
to the display. If only one DisplayPort video input cable is connected the display will run at half of the
specified refresh rate.
3. Connect the USB upstream connector with the USB host of your workstation to make optimal use of
QAWeb and the Barco Intuitive Workflow Tools, and to use the Barco Touchpad.
4. Connect the Barco Touchpad with one of the USB downstream connectors. Other peripherals like a
keyboard, mouse, etc. can also be connected.
Note: When hibernate is enabled (default setting), connect all peripherals directly to your
workstation rather than to the display’s USB ports. To disable hibernate, see “Hibernate”, page 31 .
5. Connect the supplied external DC power supply to the power input of the display.
Warning: Fasten the power connector to your display with the screws provided at the sides of the
connector.
Warning: Only use the external power supply delivered with your display. Not using the correct
power supply could cause serious damage to your display.
6. Route all cables through the cable routing channel in the stand of your display.
Installation and setup