Barco CLM R10+, User Manual

Page: 39 / 229

4. Stacking CLM projectors
D
C
B A
Image 4-4
Open the interlocking
W
ARNING
:
Never open an interlocking adapter of a stacked projector which is still suspended. First place
the stacked projectors on the fl oor.
4.2 Aligning stacked CLM projectors
How to align two stacked CLM projectors
1. Make sure that the internal hatch pattern projected by the reference projector is sharp and has a perfect rectangle outline. If this
is not the case, readjust the reference projector before aligning the other stacked projector(s) with the reference hatch pattern.
Note: The reference projector in a stacked con fi guration is the lowest projector in case of table mount and the uppermost
projector in case of ceiling mount.
2. Project with the stacked projector the same internal hatch pattern as the reference projector.
Tip: Use a white colored hatch pattern for the reference projector and e.g. green colored for the stacked projector. This
makes it easier to see the difference between both hatch patterns projected.
3. If necessary, adjust the rotation of the stacked projector with respect to the reference projector by turning in or out the height
adjustment ring of the interlocking adaptors at the front of the stacked projector. Adjust until the outline of the hatch pattern is
most symmetric with the reference hatch pattern. (image 4-5)
Tip: You can increase leverage by using a screw driver in the holes of the adjustment ring
4. If necessary, adjust the inclination of the stacked projector with respect to the reference projector by turning the height adjustment
ring of the interlocking adaptor at the rear of the stacked projector in or out. Adjust until the outline of the hatch pattern is most
symmetric with the reference hatch pattern. (image 4-6)
5. If necessary, adjust the skew of the stacked projector with respect to the reference projector by turning the screw on the right
front side. Adjust until the outline of the hatch pattern is most symmetric with the reference hatch pattern. (image 4-7)
6. Shift the hatch pattern horizontally and vertically until the outline of the hatch pattern is most symmetrically placed with respect
to the reference hatch pattern. (image 4-8)
Note: Note that the “Shift” function is motorized, which means that you have to access the projector software, via the local
keypad or remote control unit, to operate the “Shift” function.
7. Zoom the hatch pattern in or out until the outline of the hatch pattern matches exactly the outline of the reference hatch pattern.
(image 4-9)
Note: Note that the “Zoom” function is motorized, which means that you have to access the projector software, via the local
keypad or remote control unit, to operate the “Zoom” function.
R59770021 CLM R10+ 11/10/2010 35