Barco CLM HD8, User Manual

Page: 51 / 231

6. Getting started
Switching to Standby. When the projector is running and you want to go to standby, press the standby key
for 2 seconds. Do not press any longer on the standby key otherwise the projector will restart.
All custom settings are written to the internal backup device. A message ’Save data ...’ indicates this process.
Never switch off the projector while this message is displayed.
When pressing for at least 5 seconds on the Freeze button, the projector goes to standby without the risk of
restart..
6.3.4 Switching off
How to switch off the projector?
1. Press fi rst Standby .
2. Let cool down the projector until the fans decrease, at least 5 min.
3. Switch off the projector with the power switch.
C
AUTION
:
Never switch off the projector while the message ’Save data ... ’ is displayed !
6.4 Using the RCU
Pointing to the re fl ective screen
1. Point the front of the RCU to the re fl ective screen surface.
F1F2F3
F4F5
ADJ
EXIT ENTER
PAUSE PHASETEXT SHARPN TINT COLORBRIGHTNCONTRTREBLEBALANCEBASSVOL
90
7
8
5
6
34 1
2
IR Sensor (C)
Screen (B)
Remote Control (A)
Image 6-4
IR control via the re
fl ective screen
Hardwired to the XLR input
1. Plug one end of the remote cable in the connector on the bottom of the RCU
2. Plug the other end in the big connector in the input panel of the projector labelled Remote CTRL in .
Directly to one of the IR sensors
When using the wireless remote control, make sure you are within the effective operating distance (30m, 100ft in a straight line). The
remote control unit will not function properly if strong light strikes the sensor window or if there are obstacles between the remote
control unit and the projector IR sensor.
R59770057 CLM HD8 15/03/2010 47