Barco ClickShare CSE-200, Installation Manual

Page: 70 / 85

6. CSE-200 Configurator
Image 6-41
Time server setup
The current time is indicated next to Current time .
3. Check the radio button next Use NTP .
4. Enter a NTP server address next to NTP servers . Enter the IP address or server name.
Note: Multiple servers (maximum 5) can be added, separated by a comma.
5. Click Save changes to apply.
A synchronization with the NTP server takes place. The status fi eld indicates the progress.
6.25 Energy savers
About standby
Standby after (minutes) : If there is no client connection detected during the standby timeout period, the Base Unit will enter the
selected standby mode.
Default setting: Time to standby: 10 min, the Base Unit will enter the Eco standby mode.
Eco standby
When the Base Unit enters ECO standby mode, it will disable the HDMI output signal and go in low power mode. The Base Unit’s
LEDs will be breathing white to indicate the ECO standby mode.
Power consumption in Eco standby: 2.6W
The Base Unit will wake up with one of the following actions:
•
Button or app connecting with the Base Unit
• Press the standby button on the Base Unit
• "Wake up" signal over the network
• Pairing a Button on the Base Unit’s USB port
• Detection of display hot plug
Deep standby
When the Base Unit goes in Deep standby mode, it will shut down all processes, including the Wi-Fi access point and LAN connec-
tion. The Base Unit’s LEDs will be dark to indicate this standby mode.
Power consumption in Deep standby: 0.4W
The Base Unit will wake up only when the standby button on the Base Unit is pressed.
58 R5900023 CLICKSHARE CSE-200 13/07/2016