Barco C5011S, Installation Manual

Page: 93 / 158

93 R5900120 /03 ClickShare CX-50 Gen2
5.7 Display setup, Outputs
Display port
Display port output via USB Type C
TM
port at the back side of the Base Unit.
This output is enabled by default and the resolution is fixed set to
Auto
.
HDMI
When there is an HDMI connection between the Base Unit and a display, the display type is indicated. The
resolution can be selected.
Resolution
The output resolution to the display is set on Auto. That means that the CX-50 Gen2 output resolution is
automatically adapted to the resolution of the display. For HDMI displays, a hot plug detection is available.
When a display is connected to the output the Model & Vendor or indicated.
When no display is connected, the indication
Not Connected is displayed next to Model & Vendor .
Display mode
The display mode can be set to either:
• Clone mode:
Source code will be duplicated across the connected displays.
• Extended mode:
(default)
An extra window will be available for additional source content to be displayed.
It is possible to swap the position of the dual displays by changing the number after ClickShare Position .
If a touch screen is being used, its position must be set as one!
Image 5–13
CEC
Consumer Electronics Control (CEC) is a feature of HDMI designed to allow users to command and control
devices connected through HDMI by using only one remote control.
To enable CEC, check the check box before
Enable CEC
.
CX-50 Gen2 Configurator