![background image](http://html1.mh-extra.com/html/barco/barcoreality-sim6-ultra-r9040150/barcoreality-sim6-ultra-r9040150_user-manual_473908249.webp)
2. RS232 Commands
2.189 Peripheral Source, Write
Description
Select a source on an external switcher that is not in direct communication with the projector (800-port not used).
Command
Command [0]
\x33
Command [1]
\xff
Data
Data [0]
Source Number:
•
\x01
•
...
•
\63
Data [1]
External Slot Type:
•
\x01
= Video Input
•
\x02
= S-Video Input
•
\x04
= RGB Analog Input - Sync On Green
•
\x05
= RGB Analog Input - Separate Sync
•
\x06
= RGB3S/RG3SB Input - Sync On Green
•
\x07
= RGB3S/RG3SB Input - Separate Sync
•
\x08
= Component Input - Sync on Y
•
\x09
= Component Input - Separate Sync
•
\x10
= Component Input - Tri-Level Sync On Y
•
\x11
= Component Input - Tri-Level Separate Sync
Data [2]
Mode:
•
\x00
= H/C Composite Sync or H/C, V Horizontal,
Vertical Sync
•
\x01
= H/C Composite Video
The external switcher has to be connected to the projector the same way a BARCO 800 peripheral is normally
connected (see the Owner’s Manual of your projector).
The source number (Data[0]) can be used to make sure the correct file is loaded.
Example
Select source 1, type ’ RGB Analog Input - Separate Sync’, mode 0 on a projector with address
\x01
.
Transmit
Start
\xfe
Projector Address
\x01
Command [0]
\x33
Command [1]
\x80
\x7f
Data [0]
\x01
Data [1]
\x05
Data [2]
\x00
Checksum
\x39
Stop
\xff
R5976538 BARCOREALITY SIM6 ULTRA SERIES 08/06/2005
245