Barco Athena, User Manual, Page: 41 / 74

5. ICMP
Notes:
• DisplayMode = Single : is applicable to both DisplayPort A, and DisplayPort B input, separately.
• DisplayMode = A+B : inputs DisplayPort A and DisplayPort B are combined to 1 larger image; in this case the 2 DisplayPort
links need to be genlocked ( = synchronous and in phase).
• In all cases :
-
Color Space - Color Sampling:
o
YCbCr - 4:4:4
o
YCbCr - 4:2:2
o
RGB - 4:4:4
- Scan Type = progressive.
• Both Nvidia and AMD GPU’s will not support color depths of 10 bits/color while in 3D-stereo mode.
• Some Graphical Cards may not permit 10 bits/color at all video timings, because of bandwidth restrictions.
• DisplayPort A and DisplayPort B automatically detect:
-
Active Pixels, and Active Lines
- Vertical Refresh
- 8 bits/color - 10 bits/color
- Frame locked
• All input resolutions are scaled towards the desired resolution speci fi ed in the screen presentation fi le.
• Fractional frame rates = (Hz*1000)/1001
5.6 ICMP SDI speci fi cations
3G-SDI
Serial Digital Interface (SDI) is a serial link standardized by ITU-R BT.656 and the Society of Motion Picture and Tele-
vision Engineers (SMPTE). SDI transmits uncompressed digital video over 75-ohm coaxial cable within studios, and
is seen on most professional video infrastructure equipment. The
fi rst revision of the standard, SMPTE 259M, was
de fi ned to carry digital representation of analog video such as NTSC and PAL over a serial interface and is more pop-
ularly known as standard-de fi nition (SD) SDI. The data rate required to transmit SD SDI is 270 Mbps. With the advent
of high-de fi nition (HD) video standards such as 1080i and 720p, the interface was scaled to handle higher data rates
of 1.485 Gbps. The 1.485-Gbps serial interface is commonly called the HD SDI interface and is de fi ned by SMPTE
292M, using the same 75-ohm coaxial cable. Studios and other video production facilities have invested heavily on
the hardware infrastructure for coaxial cable and have a vested interest in extending the life of their infrastructure. For-
tunately, SMPTE recently rati
fi ed a new standard called SMPTE 424M that doubles the SDI data rates to 2.97 Gbps
using the same 75-ohm coaxial cable. This new standard, also called 3-Gbps (3G)-SDI, enables higher resolution of
picture quality required for 1080p and digital cinema.
SDI terminology
Standard HD-SDI signal
Single Link
1.5Gb/s HD 4:2:2
Standard HD-SDI allows for a single 4:2:2 image to be carried on one cable at 1.485 Gb/s. The image uses the Y Cb Cr colorspace
and uses a bit depth of 10 bit per color component.
Due to the data rate limitations only 23.976, 24, 25, 29.970 and 30 fps streams are achievable.
Dual-Link HD-SDI signal
Dual Link
1.5Gb/s
1.5Gb/s
1080p 50/60
1
or
1080p 4:4:4
1. Not supported in Alchemy
R5906789 ATHENA 16/12/2016 37