barbas 70-55 PF2, Installation And Maintenance Manual

Page: 37 / 84

Attach the appliance to the rear wall
1. Attach the appliance to the rear wall with 2 wedge bolts and the mounting brackets..
2. Make sure the appliance is horizontal. Use a sprit level. If necessary adjust the
mounting brackets.
Figure 25. Attachment to the rear wall
5.2.4 Make the gas connection
Important: In some countries national regulations prescribe the installation of
a gas valve in the gas supply line to the appliance at an accessible location
near the appliance. Contact your local gas supplier or your qualified gas
installer for more information on this.
1. Remove the decorative edge and the door of the operating unit.
2. Put the operating unit on maximum 50 cm from the side of the appliance
3. Remove the elastic strap that holds the gas regulator block and receiver on the
appliance and put them near the operating unit. Make sure not to disconnect
electrical cables and gas lines.
4. Put the gas regulator block, receiver, light module and if applicable the wifi-box on
the destined position in the operating unit.
Installation
Gas Fire Panorama 70-55 37