3 Getting Started
3.1 Connect to the Sensor
These instructions use Windows
®
operating system version 8, 10, or 11.
3
1. Confirm the network connections.
a) Click the
Start
button, then on the
Start
menu, click
Control Panel
.
b) In
Control Panel
, click
Network and Internet
, then click
Network and Sharing Center
, and then click
Change
adapter settings
.
c) Right-click on the connection that you want to change, then click
Properties
.
If you are prompted for an administrator password or confirmation, enter the password or provide confirmation.
d) In the connection properties, click
Internet Protocol Version 4 (TCP/IPv4)
, and then click
Properties
.
Figure 9. Local Area Connection Properties
e) In the
Internet Protocol (TCP/IPv4) Properties
, select
Use the following IP address
.
f) Make sure that the IP address is 192.168.0.2 (or an unused IP address within the 192.168.0.x subnet), and the
subnet mask is 255.255.255.0.
2. Open the Banner 3D Configuration software from the desktop or the
Start
menu.
3. Connect to the ZMX sensor using one of the following options:
•
From the
Connection
pane, enter the IP address of the desired ZMX sensor into the
Sensor IP Address
field,
then click
Connect
.
•
From the
Connection
pane, locate the IP address of the desired sensor in the list of discovered sensors, then
click
next to
IP Address
.
The default IP address for the sensor is 192.168.0.10.
3.2 Set Up the ZMX Sensor
Use the following basic steps to set up an application in the Banner 3D Configuration software.
1. Make sure the container is in place and is empty.
2. Adjust the pitch/roll/yaw if an angle correction is needed.
See
3. From the
Amplitude
view, click in the center of the container.
A green cursor displays in the center of the container and the coordinates of the cursor are shown in the lower right.
4. Copy the X, Y, and Z coordinates from the lower right of the
Image
pane into the
Anchor Point
X, Y, and Z fields in
the
Fill Level
pane.
3
Windows is a registered trademark of Microsoft Corporation in the United States and/or other countries.
ZMX Series 3D Time of Flight Sensor
www.bannerengineering.com - Tel: + 1 888 373 6767
9
