Features
The following feature callouts refer to the DX80 Gateway and Node models, the GatewayPro, and the DX83 Ethernet Bridge. The wiring
diagrams include information for connection power and sensors using the 5-pin Euro-style connect, the terminal wiring board, and the
Industrial Ethernet connection on the DX83 and GatewayPro.
DX80 Gateway and Node Components
The DX80 Gateway and Node use the same housing and include the same physical features.
1
2
3
4
5
6
7
1. Port, NPT gland, or plug. If unused, install the provided plug into the
1/2 NPT threaded port. Refer to the Installation section if an IP67 seal
is required.
2. Rotary switch 1 (left). Sets the Network ID (NID) to a hexidecimal
value from 0 to F, for a total of 16 Network IDs. A Gateway and its
corresponding Nodes must be assigned the same Network ID.
Rotary switch 2 (right). On the Gateway, sets the Gateway’s LCD
viewing device address. The Gateway is predefined as Device Ad-
dress 0. On the Node, sets the Node’s Device Address (hexidecimal 1
to F). Each Node within a network must have a unique Node Device
Address.
3. Push button 1. Single-click to advance across all top-level DX80
menus. Single-click to move down interactive menus, once a top-level
menu is chosen. Button 1 is also used to wake integrated battery mod-
els from the hibernation mode they ship in.
4. Push button 2. Double-click to select a menu and to enter manual
scrolling mode. Double-click to move up one level at a time.
5. LED 1 and 2. Provide real-time feedback to the user regarding RF link status, serial communications activity, and the error state.
6. LCD Display. Six-character display provides run mode user information and shows enabled I/O point status. This display allows the
user to conduct a Site Survey (RSSI) and modify other DX80 configuration parameters without the use of a PC or other external soft-
ware interfaces. On the Node, after 15 minutes of inactivity, the LCD goes blank. Press any button to refresh the display.
7. 5-Pin M12 Euro-style quick-disconnect serial port
DX80 Gateway and Node Wiring Chamber
The DX80 Gateway and Node use the same housing and terminal block for wiring.
rev. I
www.bannerengineering.com - tel: 763-544-3164
9
