Advanced Setup Instructions and Additional Information
Refer to the following sections for advanced setup instructions or additional information on Banner's SureCross wireless technology and
its uses.
Web-based Configuration
The DX80 wireless systems are configured using an Ethernet network connection and a common Web page browser. An Ethernet con-
nection can be established from a DX80 GatewayPro or from a DX83 Ethernet Bridge serially connected to the DX80 Gateway.
The Ethernet Bridge and GatewayPro each ship with an Ethernet crossover cable. One end of the cable is a RJ45 connector and the
other end is an industrial Ethernet connector. This cable is designed to be connected directly to a computer.
Example Layout #1
When connecting a DX80 Gateway to a host system, the wireless network must be configured using the User Configuration Tool (UCT).
When you are not using a GatewayPro or Ethernet Bridge, you cannot configure the wireless network using the Web Configurator.
1. Power connection
2. Splitter cable and Modbus RTU communication
3. DX80 Gateway
Example Layout #2
This system uses a GatewayPro connected directly to a host system using an Ethernet crossover cable. This system can be configured
using the web pages.
SureCross Wireless I/O Network Manual
40
www.bannerengineering.com - tel: 763-544-3164
rev. I
