Output Ratings
Analog Outputs:
· Current Output (T30R….-.I.. models):
1 kΩ maximum load resistance
at 24 V; maximum load resistance = [(Vcc - 4.5)/0.02 Ω]
· Voltage Output (T30R….-.U.. models):
2.5 kΩminimum load
resistance
Discrete Outputs:
· Current rating = 50 mA maximum each
Black wire specifications per configuration
IO-Link Push/Pull
Output High
≥ Vsupply - 2.5 V
Output Low
≤ 2.5V
PNP
Output High
≥ Vsupply - 2.5 V
Output Low
≤ 1V (loads ≤ 1 MegΩ)
NPN
Output High
≥ Vsupply - 2.5 V
Output Low
≤ 2.5 V
White wire specifications per configuration
PNP
Output High
≥ Vsupply - 2.5 V
Output Low
≤ 2.5 V (loads ≤ 70 kΩ)
NPN
Output High
≥ Vsupply - 2.5 V
Output Low
≤ 2.5 V
Certifications
E224071
UL Environmental Rating: Type 1
ETSI EN 305 550-1 V.1.2.1
ETSI EN 305 550-2 V.1.2.1
FCC/CFR-47 part 18
FCC ID: UE3-T30R
for others, contact Banner Engineering
Country of Origin: USA
6.1 FCC Part 15 and CAN ICES-3 (B)/NMB-3(B)
This device complies with part 15 of the FCC Rules and CAN ICES-3 (B)/NMB-3(B). Operation is subject to the following two conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules and CAN ICES-3 (B)/NMB-3(B). These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the manufacturer.
Note:
Changes or modifications made to this equipment not expressly approved by Banner Engineering Corporation may void the FCC
authorization to operate this equipment.
6.2 Industry Canada
IC ID: 7044A-T30R—This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Cet appareil est conforme aux CNR exempts de licence d'Industrie Canada. Son fonctionnement est soumis aux deux
conditions suivantes:(1) Ce dispositif ne peut causer des interférences; et(2) Ce dispositif doit accepter toute interférence, y
compris les interférences qui peuvent entraîner un mauvais fonctionnement de l'appareil.
R-GAGE
®
T30R Sensor
www.bannerengineering.com - Tel: + 1 888 373 6767
23
