Banner R-GAGE Q90R, Instruction Manual

Page: 20 / 32

February 12, 2024
Q90R R-GAGE® Radar Sensor Instruction Manual
© Banner Engineering Corp. All rights reserved.
20
Use Target Selection to set the target that the output sees.
Reset the sensor to factory default settings using one of two methods.
NOTE: If a factory reset is performed through the Banner Radar Configuration Software, the remote input
wire becomes disabled (factory default setting). If the sensor is returned to factory defaults by using the
remote input wire, the input wire remains enabled and the rest of the settings are restored to factory
defaults.
To reset using the Banner Radar Configuration software, go to Sensor › Factory Reset. The sensor indicators flash once, the
sensor is reset back to the factory default settings, and a confirmation message displays.
To reset using the remote input, eight-pulse the remote input to apply the factory defaults.
Setting Factory Default
Response Speed Medium
Signal Strength Threshold 1.0
Target Mode Nearest Target
Measurement Hold Disabled
Discrete Output & Remote Input PNP
Remote Input Wire Disabled
Action
Result
Pulses TEACH Mode
1
T
Speed = Fast
The speed is set and the power LED flashes equal
to the number of pluses, pauses, and then flashes
equal to the number of pulses a second time. The
sensor exits remote teach and returns to run mode.
2
T T
T
Speed = Medium
3
T T
T
T
T
Speed = Slow
Target Selection Mode 5.5.5
Access Target Selection mode.
Action Result
Five-pulse the remote input.
T T
T
T
T
T
T
T
T
The green power LED flashes slowly.
1.
Select the desired signal threshold.
Action
Result
Pulses TEACH Mode
1
T
Nearest Target—Output responds
to the nearest target that is over the
signal strength threshold.
The signal threshold is set and the green power
LED flashes equal to the number of pluses,
pauses, and then flashes equal to the number of
pulses a second time. Then the sensor exits
remote teach and returns to run mode
2
T T
T
Strongest Target—Output responds
to the target with the highest signal
strength that is over the signal
strength threshold.
2.
Reset the Sensor to Factory Defaults 5.6
Factory Default Settings 5.7
General Tab Default Settings Table 5.
FINAL DRAFT