0 m
1.0 m
2.0 m
Maximum Switch Point
(varies by model)
Minimum Switch Point
Sensing Range
0.4 m
Reliable detection of
stationary and moving
targets
Detection
possible, but
less likely *
*The specific detection range depends on the radar cross section and returned signal strength of the specific target.
Moving targets provide a stronger signal and are more likely to be detected at closer distances. Typical stationary
targets can be detected as close as 1 meter (3.3 feet). Typical moving targets can be detected as close as 0.4 meters
(1.3 feet).
Figure 1. Sensing Range
1.3
Banner Radar Configuration
Software
Use the Banner Radar Configuration software and Pro Converter Cable to set up the R-GAGE sensor.
For more information visit
www.bannerengineering.com/us/en/products/sensors/software/radar-configuration.html
1.4 Features and Indicators
1
3
4
2
Figure 2. R-GAGE Features
LED
Color
Description
1
Power
Green
Power ON
2
Signal
Strength
Red
Flashes in proportion
to the signal strength
3
Output 1
Amber
Output energized
4
Output 2
Amber
Output energized
Signal Strength and the Indicator LEDs
The Signal Strength indicator flashes in proportion to the signal strength. It flashes slowly when signal strength is above
one. The flashing frequency increases until signal strength is four times the user-selected signal strength threshold. At this
point, the Signal Strength indicator is on and does not flash.
R-GAGE
®
Q130RA Sensor
4
www.bannerengineering.com - Tel: + 1 888 373 6767
