Banner LTF, Instruction Manual

Page: 17 / 60

June 22, 2023
LTF Time Of Flight Laser Distance Sensor Instruction Manual
17
•
•
•
•
•
Analog Output Menu (A_OUT)
Use the Analog Output menu to view or change:
4 mA (0 V) setpoint
20 mA (10 V) setpoint
12 mA (5 V) window
Slope
Loss of signal behavior
Analog Output Menu Map
MENU A_OUT
or
or
Go Back to Parent Menu
Select Menu Item
Press to Save Setting
Press and Hold to Go Back
to Run Mode
A12000mm
00050mm
Tch4mA 50mm
Tch20mA 12000mm Tch2Pt Tch20mA
Tch2Pt Tch4mA
W02000mm
Tch12mA 6000mm TchMid Tch12mA
TchMid WndSize
Slope Negative
Slope Positive
LossSig 20.5 mA
LossSig Hold
LossSig 3.5 mA
A_OUT Adj4mA
A_OUT Adj20mA
A_OUT Tch2Pt
A_OUT TchMid
A_OUT Slope
A_OUT LossSig
Offset 0mm TchMid Offset
TEACH 4 mA (0 V) and TEACH 20 mA (10 V)
The Tch4mA (Tch0V) and Tch20mA (Tch10V) options use targets to set the 4 mA (0 V) and 20 mA (10 V) to the desired set-
points. When using the buttons, only one value needs to be set if the second value is valid. When using the remote input,
both values must be set.
Navigate: MENU › A_OUT › Tch2Pt › Tch4mA (Tch0V) or navigate: MENU › A_OUT › Tch2Pt › Tch20mA (Tch10V)
Remote input: Available
Button Instructions
Present the target.
Action Result
Present the target. The target must be within the sensor's measurement range.
The target's analog output measurement
and distance measurement values display.
1.
Access the TEACH mode and TEACH the sensor. 2.
© Banner Engineering Corp.