Verify :
Ready = 1
GatedTriggerACK
= 0
Ready
Gated
Trigger
GatedTriggerACK
= ‘1’
Read Results
RPI 0 1
X X +Y X +Y +Z M N
Gated
Trigger ACK
Set
GatedTrigger
= 1
Verify :
Ready = 1
TriggerACK = 0
Set
GatedTrigger
= 0
Set
GatedTrigger
= 1
Set
GatedTrigger
= 0 (Abort )
Inspection
could not be
completed
Gated Trigger
Figure 175. Gated Trigger Timing Diagram
14.9 Command Channel Command Status Register
The command status register will confirm receipt of a command by reflecting the exact command ID received, regardless of
whether the command was valid or not.
14.10 Diagnostic Guide
iVu BCR devices provide several methods to help diagnose communication issues when using Ethernet communications.
14.10.1 Ethernet Diagnostics
To verify Ethernet connectivity, follow these steps:
1. Verify that all of the cables are connected and properly seated.
2. Examine the Ethernet I/O LED located on the top of the iVu BCR, between the Pass/Fail and System Status LEDs.
The light should be either on or blinking.
3. Go to System > Logs > System Log.
4. Verify that the log entry indicates that the Ethernet link is up:
iVu Plus BCR Gen2 Series Sensor
168
www.bannerengineering.com - Tel: + 1 888 373 6767
