Filter Kits
For use with the iVu Series
TG
Image Sensor
This document describes how to install red, blue, green, or infrared filters in the iVu Series sensor.
Models
Description
Model
Red filter kit
FLTMR
IR Filter kit
FLTMI
Blue filter kit
FLTMB
Green filter kit
FLTMG
Installing Filters on the iVu Series Sensor
To install a filter on the iVu Series sensor, use the illustration as a guide and follow the steps listed below.
Note: Failure to follow these instructions can cause damage to your iVu Series sensor.
Lens
A
Focusing Window
B
Locking Clip
C
Locking Screw
D
Filter Cap
E
Filter
F
1. Use the 1/16" hex key to remove the Focusing Window locking screw (D).
Note: The Locking Clip (C) inserts in a groove near the top of the Focusing Window. When removing
the window, the Locking Clip will be loose. Be careful not to lose the clip while removing the window.
2. Unscrew the Focusing Window by turning it clockwise approximately 5 complete turns or until the Focusing
Window disengages from the light/lens assembly.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]
