Banner EZ-SCREEN SLS, Instruction Manual

Page: 72 / 114

May 22, 2023
EZ-SCREEN SLS Safety Light Curtain Instruction Manual
(1)
Multiple DEE2R-..D cables may be required.
72
•
•
Optional housing finishes include the following. Add the model code before the QD designation in the model number:
add “A” for a clear (brushed) anodized aluminum finish, black endcaps (e.g., SLSCE30-300AQ8),
add “S” for a nickel-plated (“silver”) finish, black endcaps (e.g., SLSCE30-300SQ8),
In Run mode, the 7-digit display shows the following.
Condition Display
Clear Condition—Latch output operation
Clear Condition—Trip output operation
Blocked Number of blocked beams (sequential)
CSSI Input Off or open, for example, “upstream” receiver is blocked or in
lockout
Solid (not flashing)
The following cable length charts are possible combinations for each side of example cascaded systems. All cables are as-
sumed to be 22 awg wire. Other lengths and combinations are possible; please call factory for assistance.
As the machine interface cable lengthens, the voltage drop increases, which results in shorter possible interconnect cables to
maintain supply voltage requirements at the cascaded sensor. See " Cordsets " on page 91 for a list of cordsets.
Machine Interface Cable (L1) QDE-..D 1 ft 3 ft 15 ft 25 ft 50 ft
Maximum L2
(1)
200 ft 200 ft 175 ft 135 ft 50 ft
Sensor Interconnect
Cable Lengths (L2)
Individual DEE2R-..D
cables (ft)
100 100 100 100
Emitters
Machine
Control
Receivers
L2
L1
EZ-SCREEN
Position #2
EZ-SCREEN
Position #1
75 75 75 75
50 50 50 50 50
25 25 25 25 25
15 15 15 15 15
3 3 3 3 3
1 1 1 1 1
Example 1:
Machine Interface Cable (L1): 15 ft
Sensor Interconnect Cable (L2): 175 ft (Using one 100 ft and one 75 ft DEE2R cables) or 100 ft or shorter using single ca-
bles
Example 2:
Machine Interface Cable (L1): 50 ft
Receiver Display
8.3
Determining Interconnect Cable Lengths
8.4
Cable length options for two cascaded light screens (recommended cable pairing per side of the cascaded sys-
tem)
Table 7.
© Banner Engineering Corp.