Banner EZ-SCREEN SLS, Instruction Manual

Page: 14 / 114

May 22, 2023
EZ-SCREEN SLS Safety Light Curtain Instruction Manual
14
EDM Input
+24 V DC signals from external device contacts can be moni-
tored (one-channel, two-channel, or no monitoring) via EDM1
terminal in the receiver.
High Signal: 10 to 30 V DC at 30 mA typical
Low Signal: 0 to 3 V DC
Dropout Time: 200 ms maximum
Reset Input
Reset input must be high for 0.25 to 2 seconds and then low
to reset the receiver
High Signal: 10 to 30 V DC at 30 mA typical
Low Signal: 0 to 3 V DC
Closed Switch Time: 0.25 to 2 seconds
Ambient Light Immunity
10,000 lux at 5° angle of incidence
Controls and Adjustments
Scan Code selection: 2-position switch (code 1 or 2). Factory
default position is code 1
Trip/Latch Output selection: Redundant switches. Factory de-
fault position is
T (trip).
EDM/MPCE Monitor selection: 2-position switch selects be-
tween 1- or 2-channel monitoring. Factory default position
is 2-channel monitoring.
Reduced Resolution: Redundant switches. Factory default po-
sition is
Off.
Status Indicators
Amber Reset Indicator: indicates whether the System is ready
for operation or requires a reset
Bi-color (red/green) Status indicator: indicates general system
and output status
Bi-color (red/green) Zone Status indicators: indicate condition
(clear or blocked beam) of a defined group of beams
7-Segment Diagnostic indicator (3 digits): indicates proper op-
eration, scan code, error code, or total number of blocked
beams
Strobe Light Immunity
Totally immune to one Federal Signal Corp. "Fireball" model
FB2PST strobe
Recovery Time
Blocked to Clear (OSSDs turn On; varies with total number of
sensing beams and whether Sync beam is blocked):
Model Beam 1 (Sync Beam) All Other Beams
14 mm 109 ms to 800 ms 33 ms to 220 ms
30 mm 81 ms to 495 ms 25 ms to 152 ms
These are the emitter and receiver mounting dimensions and the location of the defined area.
Y
L1
L2
L3
*For SLS..-150 models, this distance is 52 mm (2")
Dimensions
3.6.4
© Banner Engineering Corp.