设备使用说明书
第
7
页 共
23
页
8 DEVICE MENU
8.1 Main menu
8.1.1 Turn on the device in accordance with section 6 of this Manual. After switching on the device, press the
"menu"
button. The device will display the main menu as in Figure 8.1.
Figure 8.1 – Main menu of the device
8.1.2. Each section of the main menu has its own purpose:
Frequency
– menu section where the user sets the frequencies at which devices or loads are tested.
Plots
– the section of the main menu where you can select and configure the parameters of the charts and
plots displayed on the screen.
Markers
– section for setting visual markers and setting parameters for their display during measurements.
Calibration
– menu for calibration of the device.
Device
– this section specifies the device serial number and the software version.
Presets
– section to save user settings.
Traces
– section to save the results of the current measurements (traces) with the subsequent possibility of
loading and comparing them.
8.1.3. To exit the main menu, press the
“menu”
button. To quickly exit from any menu to the displayed plots,
press the
“plot”
button.
8.2 Frequency setting menu
The frequency plan consists of the parameters by which the synthesizer sweeps and sets the measurement
mode (frequency range, number of measurement points, digital filter bandwidth)
8.2.1. To set the frequency plan enter the main menu of the device (Figure 8.1) by pressing the
“menu”
button. Enter the
Frequency
section. A menu will appear on the screen, as in Figure 8.2.
