Technical data
38
Automation PC 3100 User's manual V 1.00
Translation of the original documentation
2.2.6.3 Ethernet 1 interface (ETH1)
This Ethernet controller is routed externally via the system unit.
Ethernet 1 interface (ETH1
1)
)
Controller
Intel I219
Wiring
S/STP (Cat 5e)
Transfer rate
10/100/1000 Mbit/s
2)
Cable length
Max. 100 m (min. Cat 5e)
LED "Speed"
On
Off
Green
100 Mbit/s
10 Mbit/s
3)
Orange (dark)
1000 Mbit/s
-
LED "Link"
On
Off
Orange (light)
Link (a connection to an
Ethernet network exists)
Activity (blinks) (data
is being transferred)
RJ45, female
1
Table 23: Ethernet interface (ETH1)
1)
The interfaces, etc. available on the device or module have been numbered for the purpose of clear differentiation. This numbering may deviate from the
numbering used by the respective operating system, however.
2)
Switching takes place automatically.
3)
The 10 Mbit/s transfer rate / connection is only available if LED "Link" is active at the same time.
A special driver is required to operate the Ethernet controller. Drivers for approved operating systems are available
for download in the Downloads section of the B&R website (
Information:
Necessary drivers must be downloaded from the B&R website, not from manufacturer websites.
2.2.6.4 Ethernet 2 interface (ETH2)
This Ethernet controller is routed externally via the system unit.
Ethernet 2 interface (ETH2
1)
)
Controller
Intel I210
Wiring
S/STP (Cat 5e)
Transfer rate
10/100/1000 Mbit/s
2)
Cable length
Max. 100 m (min. Cat 5e)
LED "Speed"
On
Off
Green
100 Mbit/s
10 Mbit/s
3)
Orange (dark)
1000 Mbit/s
-
LED "Link"
On
Off
Orange (light)
Link (a connection to an
Ethernet network exists)
Activity (blinks) (data
is being transferred)
RJ45, female
1
Table 24: Ethernet interface (ETH2)
1)
The interfaces, etc. available on the device or module have been numbered for the purpose of clear differentiation. This numbering may deviate from the
numbering used by the respective operating system, however.
2)
Switching takes place automatically.
3)
The 10 Mbit/s transfer rate / connection is only available if LED "Link" is active at the same time.
A special driver is required to operate the Ethernet controller. Drivers for approved operating systems are available
for download in the Downloads section of the B&R website (
Information:
Necessary drivers must be downloaded from the B&R website, not from manufacturer websites.
StockCheck.com