Technical data
Panel PC 2100 user's manual V1.17
51
2.2.4.3 Ethernet 1 interface (ETH1)
This Ethernet controller is connected to external devices via the system unit.
Ethernet 1 interface (ETH1
1)
)
Controller
Intel I210
Wiring
S/STP (Cat 5e)
Transfer rate
10/100/1000 Mbit/s
2)
Cable length
Max. 100 m (min. Cat 5e)
LED "Speed"
On
Off
Yellow
100 Mbit/s
10 Mbit/s
3)
Green
1000 Mbit/s
-
LED "Link"
On
Off
Green
Link (indicates connection
to an Ethernet network)
Activity (blinks to indi-
cate active data transfer)
RJ45, female
1
LED "Speed"
LED "Link"
Table 38: Ethernet interface (ETH1)
1)
The interfaces, etc. available on the device or module have been numbered as such for the purpose of clear differentiation. This numbering may deviate
from the numbering used by the respective operating system, however.
2)
Switching takes place automatically.
3)
The 10 Mbit/s transfer rate / connection only exists if LED "Link" is also lit at the same time.
Driver support
A special driver is required to operate the Ethernet controller. Drivers for approved operating systems are available
for download in the Downloads section of the B&R website (
Information:
Only download necessary drivers from the B&R website, not from vendor websites.
2.2.4.4 Ethernet 2 interface (ETH2)
This Ethernet controller is connected to external devices via the system unit.
Ethernet 2 interface (ETH2
1)
)
Controller
Intel I210
Wiring
S/STP (Cat 5e)
Transfer rate
10/100/1000 Mbit/s
2)
Cable length
Max. 100 m (min. Cat 5e)
LED "Speed"
On
Off
Yellow
100 Mbit/s
10 Mbit/s
3)
Green
1000 Mbit/s
-
LED "Link"
On
Off
Green
Link (indicates connection
to an Ethernet network)
Activity (blinks to indi-
cate active data transfer)
RJ45, female
1
LED "Speed"
LED "Link"
Table 39: Ethernet interface (ETH2)
1)
The interfaces, etc. available on the device or module have been numbered as such for the purpose of clear differentiation. This numbering may deviate
from the numbering used by the respective operating system, however.
2)
Switching takes place automatically.
3)
The 10 Mbit/s transfer rate / connection only exists if LED "Link" is also lit at the same time.
Driver support
A special driver is required to operate the Ethernet controller. Drivers for approved operating systems are available
for download in the Downloads section of the B&R website (
Information:
Only download necessary drivers from the B&R website, not from vendor websites.
