Technical data
Panel PC 2100 user's manual V1.17
195
Model number
5ACCIF01.FPSC-001
POWERLINK
Quantity
1
Transfer
100BASE-TX
Type
Type 4
2)
Design
Shielded RJ45
Transfer rate
100 Mbit/s
Cable length
Max. 100 m between two stations (segment length)
CAN
Quantity
1
Design
10-pin, male, electrically isolated
Transfer rate
Max. 1 Mbit/s
Terminating resistor
Type
Can be enabled or disabled using a slide switch
X2X
Type
X2X Link master
Quantity
1
Design
10-pin, male, electrically isolated
Electrical characteristics
Power consumption
2 W
Operating conditions
Pollution degree per EN 61131-2
Pollution degree 2
Environmental conditions
Temperature
Operation
-20 to 55°C
Storage
-20 to 60°C
Transport
-20 to 60°C
Relative humidity
Operation
5 to 90%, non-condensing
Storage
5 to 95%, non-condensing
Transport
5 to 95%, non-condensing
Mechanical characteristics
Weight
25 g
Table 188: 5ACCIF01.FPSC-001 - Technical data
1)
Yes, although applies only if all components installed in the complete system have this certification and the complete system bears the corresponding mark.
2)
For more information, see Automation Help (Communication - POWERLINK - General information - Hardware - IF / LS).
2.3.5.7.3.1 POWERLINK interface - Pinout
The POWERLINK interface on the system unit is referred to as IF1.
POWERLINK - IF1
1)2)
Wiring
S/STP (Cat 5e)
Cable length
Max. 100 m (min. Cat 5e)
Status LED
On
Off
Green
See Status/Error LED.
Link LED
On
Off
Yellow
Link (POWERLINK net-
work connection available)
Activity (blinks to indi-
cate active data transfer)
RJ45, female
1
LED "Status"
LED "Link"
Table 189: 5ACCIF01.FPSC-001 - POWERLINK interface
1)
The interfaces, etc. available on the device or module have been numbered as such for the purpose of clear differentiation. This numbering may deviate
from the numbering used by the respective operating system, however.
2)
This interface is referred to as IF1 in Automation Studio / Automation Runtime.
