B&R MAPPC800-ENG, User Manual

Page: 139 / 396

Commissioning • Connection examples
Section 3
Com
m
is
sio
ning
139 Panel PC 800 User's Manual V 1.00
4.3 One Automation Panel 900 via SDL
One Automation Panel 900 is connected to the integrated SDL interface via an SDL cable. USB
devices can only be connected directly to the Automation Panel (without a hub).
4.3.1 Basic system requirements
The following table displays the possible combinations for the PPC800 system unit with CPU
board to implement the configuration shown in the figure above. If the maximum resolution is
limited when making the combination then it is also shown in the following table (e.g. for
connecting a non-B&R Automation Panel 900 device).
Figure 65: Configuration - One Automation Panel 900 via SDL
CPU board with system unit Limitation
Resolution
5PC820.1505-00 5PC820.1906-00
5PC800.B945-00
5PC800.B945-10
✓ ✓
Max. UXGA
5PC800.B945-01
5PC800.B945-11
✓ ✓
Max. UXGA
5PC800.B945-02
5PC800.B945-12
✓ ✓
Max. UXGA
5PC800.B945-03
5PC800.B945-13
✓ ✓
Max. UXGA
5PC800.B945-04
5PC800.B945-14
✓ ✓
Max. UXGA
5PC800.B945-05
✓ ✓
Max. UXGA
Table 73: Possible combinations of system unit and CPU board
Panel PC 800
SDL segment
max. 40 meters
Link: 5DLSDL.1000-00
USB OK
0
SDVO-B
x
Monitor / Panel
connection
Not dependent on segment length
Internal device numbers on the PPC