B&R MAPPC700A-ENG, User Manual

Page: 313 / 524

Software • Upgrade information
Ch
apte
r 4
Soft
w
are
313 Panel PC 700 with 945GME N270 CPU board User's Manual V 1.16
Which firmware is installed on the Automation Panel Link Transceiver/Receiver?
This information can be found on the following BIOS setup page:
• After switching on the PPC700, you can get to the BIOS Setup by pressing "F2" or "DEL".
• From the BIOS main menu "advanced" (top), select "baseboard/panel features" (bottom)
and then "panel control":
Information:
The version can only be shown if an Automation Panel with Automation Panel Link
SDL transceiver (5DLSDL.1000-01) and Automation Panel Link SDL receiver
(5DLSDL.1000-00) is connected.
Figure 174: Firmware version of Automation Panel Link SDL transceiver/receiver
Advanced
Panel Control Panel 0-14: connected
to Automation Panel
Link or Monitor/Panel
connector.
Brightness: [100%] Panel 15: connected on
Panel PC Link.
Note: DVI and PPC Link
will show no valid
values. On OOC Link
only the brightness
option will work.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Select Panel Number [0]
Version: V1.17
Temperature: 41°C/105°F
Fan Speed: 00RPM
Keys/Leds: 128/128
BIOS SETUP UTILITY
v02.57 (C)Copyright 1985-2004, American Megatrends, Inc.
FPGA firmware of the
SDLR controller