Commissioning • Installation
Chapter 3
Com
m
is
sio
ning
219
Panel PC 700 with 945GME N270 CPU board User's Manual V 1.16
Chapter 3 • Commissioning
1. Installation
Panel PC 700 devices are best mounted in a housing cutout using the clamps found on the
housing (different designs possible). The cutout dimensions for the respective Panel PC 700
device can be found in the technical data for the system units (see chapter 2 "Technical data"
starting on page 37).
The mounting clamps are designed for a max. thickness of 10 mm for the material where the
device is being clamped. The minimum thickness is 2 mm.
In order to tighten or loosen the screws, a hex key (size 3) is required for the plastic clamps and
a Torx screwdriver (size 20) or a large flat-head screwdriver for the aluminum die casting.
The maximum torque when tightening the clamp is 0.5 Nm. A Panel PC 700 unit must be
mounted to a flat surface. Uneven areas can cause damage to the display when the screws are
tightened.
Figure 119: Terminal block
Plastic (PA6)
with clip
Aluminum dye cast
with clip
Aluminum dye cast
without clip
Close
Open
Close
Open
Close
Open
Clamping le
ve
r
Clamping le
ve
r
Clamping le
ve
r
Clips
Summary of Contents for MAPPC700A-ENG
