Software • B&R Automation Device Interface (ADI) - Control Center
Chapter 4 Software
Automation PC 810 with GM45 CPU board user's manual V1.28
277
9.3 SDL Equalizer settings
1. Open the
Control Center
in the
Control Panel
.
2. Select
Display
tab.
3. Click on
Settings
. This opens the following dialog box:
Figure 149: ADI Control Center - SDL equalizer settings
You can change the display's SDL equalizer settings in this dialog box. The equalizer is integrated into Automation
Panel devices and adapts the DVI signal to various cable lengths. The equalizer value is automatically calculated
based on the cable length. It is possible to set a different equalizer value in order to obtain the best possible display
quality (e.g. in case of low-quality cables or poor DVI signal quality).
The value is optimally defined for the cable length when using the "Automatic setting".
The equalizer value can only be changed if the function is supported by Automation Panel 900 (starting with Panel
Firmware version 1.04 or higher).
