General information • Safety notices
Section 1
Genera
l in
forma
tion
23
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
•
Electrostatic discharges should be avoided on the components (e.g. through charged
plastics).
•
A minimum distance of 10 cm must be kept from monitors and TV sets.
•
Measurement devices and equipment must be grounded.
•
Measurement probes on potential-free measurement devices must be discharged on
sufficiently grounded surfaces before taking measurements.
Individual components
•
ESD protective measures for individual components are thoroughly integrated at B&R
(conductive floors, footwear, arm bands, etc.).
The increased ESD protective measures for individual components are not necessary for our
customers for handling B&R products.
2.3 Policy and procedures
Electronic devices are generally not failsafe. In the event of a failure on the programmable
control system operating or monitoring device, or uninterruptible power supply, the user is
responsible for ensuring that other devices that may be connected, e.g. motors, are in a secure
state.
Both when using programmable logic controllers and when using operating and monitoring
devices as control systems in conjunction with a soft PLC (e.g. B&R Automation Runtime or
comparable products) or a slot PLC (e.g. B&R LS251 or comparable products), the safety
precautions applying to industrial control systems (e.g. the provision of safety devices such as
emergency stop circuits, etc.) must be observed in accordance with applicable national and
international regulations. The same applies for all other devices connected to the system, such
as drives.
All tasks such as installation, commissioning, and maintenance are only permitted to be carried
out by qualified personnel. Qualified personnel are persons familiar with transport, ounting,
installation, commissioning, and operation of the product who also have the respective
qualifications (e.g. IEC 60364). National accident prevention guidelines must be followed.
The safety guidelines, connection descriptions (type plate and documentation), and limit values
listed in the technical data are to be read carefully before installation and commissioning and
must be observed.
2.4 Transport and storage
During transport and storage, devices must be protected from excessive stress (mechanical
load, temperature, humidity, aggressive atmospheres, etc.).
2.5 Installation
Summary of Contents for Automation PC 620
Page 2: ...2 Automation PC 620 with 945GME N270 CPU board User s Manual V 1 10 ...
Page 4: ...4 Automation PC 620 with 945GME N270 CPU board User s Manual V 1 10 ...
Page 6: ...6 Automation PC 620 with 945GME N270 CPU board User s Manual V 1 10 ...
Page 568: ...568 Appendix A Glossary Automation PC 620 with 945GME N270 CPU board User s Manual V 1 10 ...