Software • B&R Automation Device Interface (ADI) - Control Center
280
Automation PC 810 with GM45 CPU board user's manual V1.28
Figure 152: ADI Control Center - UPS battery settings
In this dialog box you can change the settings for the UPS battery.
Click
OK
to write the changed settings to the file. The battery settings for the UPS can then be updated with this file.
Information:
To make settings for batteries not from B&R, it is best to make a copy of a file with battery settings
from B&R under a new name and make adjust the settings in this file for the battery being used.
Current files with settings for batteries from B&R can be updated using B&R's "Upgrade PPC800 MTCX" software.
Information:
•
The current UPS firmware version 1.10 does not use charge end voltage, deep discharge volt-
age, lifespan and deep discharge cycles.
•
Lifespan is only included in version 2 (and higher) of the UPS battery settings and only valid
for B&R UPS batteries at 25°C ambient temperature.
•
Deep discharge cycles are only included in version 3 (and higher) of the UPS battery settings
and only valid for B&R UPS batteries.
Information:
If you would like to change the current battery settings on the UPS, they must first be saved in a file.
9.4.4 Updating the UPS battery settings
1. Open the
Control Center
in the
Control Panel
.
2. Select the
UPS
tab.
3. Under
Battery settings
, click on
Update
. Clicking on "Open" opens a dialog box.
4. Select and
open
the file containing the battery settings. The "Download" dialog box is opened.
The transfer can be canceled by clicking on
Cancel
. Cancel is disabled when the flash memory is being written to.
Information:
•
The UPS cannot be operated while updating the battery settings.
•
If the transfer is interrupted, then the procedure must be repeated until the battery settings have
been updated successfully. Otherwise battery operation will no longer be possible.