Accessories
118
Mobile Panel 40/50 User's manual V1.80
6.5 Box cable
6.5.1 5CAMPB.0100-10
6.5.1.1 General information
A box cable establishes the electrical connection between the
control
cabinet and connection box
4MPCBX.0000-00. It includes lines for the network (
Ethernet
10/100 Mbit/s), 24 VDC power supply
3)
,
control
de-
vices or stop / emergency stop and key
switch
es or pushbuttons, enable
switch
es, serial transfer and
CAN
.
The connection side has a pre-assembled RJ45
Ethernet
connector. The remaining lines have an open end and
wire end sleeves to make it easier to wire to
safety
equipment and other interfaces. The box cable is installed in
the connection box on the other side (connection box side).
Ethernet RJ45 +
Shield (4 wires)
Enable switch
(6 wires)
Cable gland
RS232
(3 wires)
Control devices
(6 wires)
CAN 1 & CAN 2
+ shield
(5 wires)
Power supply
+ grounding
(3 wires)
Female Ethernet RJ45 con shield
(ST2) (4 wires)
Stop / Emergency stop (ST5)
(4 wires)
RS232 (ST4)
(3 wires)
Enable switch (ST7)
(6 wires)
CAN 1 & CAN 2
+ shield
(ST3) (5 wires)
Power supply
+ grounding (ST1)
(3 wires)
M3 cable lug
Connection side for
Control cabinet
Connection box side
Key switch or
Pushbutton (ST6)
(2 wires)
Figure 81: 5CAMPB.0xxx-10 - Connections
The pinout of the
Ethernet
RJ45 connector (crossover) makes it possible to connect it directly to a B&R
controller
or to the 1st
Ethernet
connection (MDIX) on B&R
Ethernet
hub
AC808 (model number 0AC808.9).
If a different
Ethernet
hub
is used, it must support crossed over RX and TX lines.
The surface is protected against water, oil (lubricating and hydraulic oils per
EN
60811 Part 2-1) and cooling
lubricant.
6.5.1.2 Order data
Model number
Short description
Figure
Accessories
5CAMPB.0100-10
Mobile Panel box cable - With wire end sleeves - With connector
contacts
Table 68: 5CAMPB.0100-10 - Order data
6.5.1.3 Technical data
Information:
The following specified characteristic data, features and limit values are only valid for these individual
components and may differ from those of the complete system. The data specified for the complete
system applies to the complete system in which this individual component is used, for example.
Model number
5CAMPB.0100-10
General information
Certifications
CE
Yes
GOST-R
Yes
Cable construction
Type
Hybrid cable, 25 wires
Properties
Halogen- and silicone-free
Supply lines
Material
Tinned copper stranded wire
Permissible operating voltage
30 VDC
Table 69: 5CAMPB.0100-10 - Technical data
3)
EN
60950 requirements must be observed; see section "+24 VDC power supply" of the user's manual.
