B&R Industries X20 System, User Manual

Page: 468 / 2720

X20 system modules • Analog output modules • X20AO2632-1
468 X20 system User's Manual 3.10
Product ID X20AO2632-1
Max. error at 25°C
Voltage
Gain 0.050%
1)
Offset 0.015%
2)
Current
Gain 0.080%
1)
Offset 0.050%
2)
Output protection Short circuit protection
Output format
Voltage INT 0x8000 - 0x7FFF / 1 LSB = 0x0001 = 335.693 µV
Current INT 0x0000 - 0x7FFF / 1 LSB = 0x0001 = 671.386 nA
Load per channel
Voltage Max. ±11 mA, load ≥1 kΩ
Current Max. load is 600 Ω
Short circuit protection Current limiting ±40 mA
Output filter 1st-order low pass / cutoff frequency 10 kHz
Max. gain drift
Voltage 0.008 %/°C
1)
Current 0.011 %/°C
1)
Max. offset drift
Voltage 0.003 %/°C
2)
Current 0.008 %/°C
2)
Error caused by load change
Voltage Max. 0.10%, from 10 MΩ → 1 kΩ, resistive
Current Max. 0.50%, from 1 Ω → 600 Ω, resistive
Non-linearity <0.007%
3)
Isolation voltage between channel and bus 500 V
eff
Operating conditions
Mounting orientation
Horizontal Yes
Vertical Yes
Installation at elevations above sea level
0 to 2000 m No limitations
>2000 m Reduction of ambient temperature by 0.5°C per 100 m
EN 60529 protection IP20
Environmental conditions
Temperature
Operation
Horizontal installation -25 to 60°C
Vertical installation -25 to 50°C
Derating -
Storage -40 to 85°C
Transport -40 to 85°C
Relative humidity
Operation 5 to 95%, non-condensing
Storage 5 to 95%, non-condensing
Transport 5 to 95%, non-condensing
Mechanical characteristics
Note Order 1x X20TB06 or X20TB12 terminal block separately
Order 1x X20BM11 bus module separately
Spacing 12.5
+0.2
mm
Table 97: X20AO2632-1 - Technical data
1) Based on the current output value.
2) Based on the entire output range.
3) Based on the output range.
4.4.6.4 LED status indicators
Figure LED Color Status Description
Off No power to module
Single flash RESET mode
Double flash BOOT mode (during firmware update)
1)
Blinking PREOPERATIONAL mode
r Green
On RUN mode
Off No power to module or everything OK e Red
On Error or reset status
Off Value = 0 1 - 2 Orange
On Value ≠ 0
Table 98: LED status indicators
1) Depending on the configuration, a firmware update can take up to several minutes.