480
Software • Power Panel 300 with BIOS
Power Panel 300/400 User's Manual V 2.30
1.6 Software updates
The following Power Panel device software and firmware can be updated:
•
BIOS (see page 488)
•
MTCX firmware (see page 491)
•
aPCI firmware (see page 493)
•
User Boot Logo (see page 494)
Current software can be downloaded directly from the service portal on the B&R homepage
(
).
The version information can be found in the corresponding BIOS setup pages, or via ADI
"Control Center" (included in Windows XP embedded and Windows CE).
1.7 CMOS backup
To protect CMOS data, a CMOS backup has been integrated into BIOS. If the BIOS setup was
ended using "Save values and exit" and the Power Panel device was successfully restarted, then
the CMOS data is burned to flash memory. If the CMOS checksum is incorrect during startup
(battery dead) or the Power Panel device cannot be booted correctly three times consecutively,
then the salvaged data from flash memory is copied again to CMOS. Setup is back to its original
state, except for the time.
Summary of Contents for Power Panel 300
