Installation • Installation
90
Panel PC 2100 swing arm user's manual V1.00
1.6 Installing the handles
1. Disconnect the power supply to the Panel PC (disconnect the power cable). Isolate the system from all
potential sources of electrical power!
2. Discharge any electrostatic charge on the ground connection.
3. Place the Panel PC on a clean, flat surface.
4. Remove the Torx screws (T20) indicated in the following image.
Figure 47: Removing the Torx screws
5. Place a large sealing ring
(①,
6 mm) in each of the mounting holes.
6. Insert the two centering plates
(②)
into the handle
(③).
The rounded sides must be lined up.
7. Place each Torx screw
(⑤)
through a small sealing ring
(④,
4 mm).
8. Insert the handle
(③)
with the mounted centering plates
(②)
in the mounting holes.
9. Insert the Torx screws
(⑤,
T20) through the previously mounted components and tighten with a max. tight-
ening torque of 1.27 Nm.
Figure 48: Installing the handles
