Technical data • Complete system
Chapter 2
Technical data
Panel PC 2100 swing arm user's manual V1.00
31
2.4.3 Ethernet 1 interface (ETH1)
This Ethernet controller is integrated in the mainboard and connected to external devices via the system unit.
Ethernet 1 interface (ETH1
1)
)
Controller
Intel I210
Cabling
S/STP (Cat 5e)
Transfer rate
10/100/1000 Mbit/s
2)
Cable length
Max. 100 m (min. Cat5e)
Speed LED
On
Off
Orange
100 Mbit/s
10 Mbit/s
3)
Green
1000 Mbit/s
-
Link LED
On
Off
Orange
Link (Ethernet network
connection available)
Activity (blinking - da-
ta transfer in progress)
Female RJ45 connector
1
Speed LED
Link LED
Table 23: Ethernet interface (ETH1)
1)
The interfaces, etc. available on the device or module have been numbered as such for easy identification. This numbering may differ from that used by
the particular operating system.
2)
Switching takes place automatically.
3)
The 10 Mbit/s transfer speed / connection only exists if the Link LED is also lit at the same time.
Driver support
A special driver is required to operate the Ethernet controller. Drivers for approved operating systems are available
in the Downloads section of the B&R website (
Information:
Required drivers can only be downloaded from the B&R website, not from manufacturer websites.
2.4.4 Ethernet 2 interface (ETH2)
This Ethernet controller is integrated in the mainboard and connected to external devices via the system unit.
Ethernet 2 interface (ETH2
1)
)
Controller
Intel I210
Cabling
S/STP (Cat 5e)
Transfer rate
10/100/1000 Mbit/s
2)
Cable length
Max. 100 m (min. Cat5e)
Speed LED
On
Off
Orange
100 Mbit/s
10 Mbit/s
3)
Green
1000 Mbit/s
-
Link LED
On
Off
Orange
Link (Ethernet network
connection available)
Activity (blinking - da-
ta transfer in progress)
Female RJ45 connector
1
Speed LED
Link LED
Table 24: Ethernet interface (ETH2)
1)
The interfaces, etc. available on the device or module have been numbered as such for easy identification. This numbering may differ from that used by
the particular operating system.
2)
Switching takes place automatically.
3)
The 10 Mbit/s transfer speed / connection only exists if the Link LED is also lit at the same time.
Driver support
A special driver is required to operate the Ethernet controller. Drivers for approved operating systems are available
in the Downloads section of the B&R website (
Information:
Required drivers can only be downloaded from the B&R website, not from manufacturer websites.
