Standards and certifications • Certifications
162
Panel PC 2100 swing arm user's manual V1.00
2 Certifications
Danger!
A complete system can only receive certification if ALL of the individual components it includes have
the applicable certifications. If an individual component is being used that DOES NOT have an applic-
able certification, then the complete system WILL NOT receive certification.
B&R products and services comply with applicable standards. This includes international standards from organi-
zations such as ISO, IEC and CENELEC, as well as national standards from organizations such as UL, CSA, FCC,
VDE, ÖVE, etc. We are committed to ensuring the reliability of our products in an industrial environment.
Unless otherwise specified, the following certifications apply:
2.1 UL certification
Products with this mark have been tested by Underwriters Laboratories and are listed
as "Industrial Control Equipment". This mark is valid for the USA and Canada and
simplifies the certification of your machines and systems in these areas.
Underwriters Laboratories (UL) in accordance with the UL508 standard - 17th Edition
Canadian (CSA) standard in accordance with C22.2 No. 142-M1987
2.2 FCC and IC
B&R products satisfy EMC requirements for operation in the USA and Canada and are compliant with FCC and IC
regulations. Corresponding "Radio Frequency Interference Statements" for the USA and Canada:
USA:
Federal Communi-
cations Commission
(FCC)
This device complies with Part 15 of the FCC Rules and with Industry Canada li-
cense-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Canada:
Industry Canada (IC)
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux ap-
pareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
If products are also equipped with an RFID read/write unit, it must be approved for operation in the USA and
Canada. These types of products are identified by a sticker with "Contains FCC ID:" and "Contains IC ID:" on the
RFID read/write unit. In addition to the additional sticker for products with an RFID read/write unit, the requirements
below also apply.
Information:
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
