©
Bandit Technologies Inc.
4. Ensure the seat is securely held in place to complete seat installation.
2d Assemble Fender and Headlight
1. Remove the front and rear fenders.
2. Loosen the screw located at the top by twisting it counterclockwise.
3. Once the screw is loose, place the headlight directly on top of the front
fender.
4. Re-install the screw to fasten the headlights and front fender together.
5. Repeat the same process for the rear fender.
2e Mounting Pedals
Warning: Incorrect installation will cause damage. Please carefully read and
follow the instructions. Ensure the pedals are secure before riding and re-
tighten after every few rides.
1. Identify and prepare the left and right pedals by their “L” and “R”
markings.
2. The pedal “R” should be installed on the right side of the chainring
while pedal “L” should be installed on the left.
3. Install pedal “R” by twisting it clockwise.
4. Install pedal “L” by twisting it counter-clockwise.
Note: Hand screw the pedals to get the thread started. Afterwards, use your
15mm wrench to tighten them.
3 Battery & Monitor Instructions
3a Charging Your Battery
1. Flip open the flap and plug the wire into the socket to begin charging.
2. The battery can also be removed for charging by using the provided key
to release it from its slot.
3. Plug the charger into a power source.
4. A red light shows that the battery is being charged while green means
it’s full.
Page | 3
