• Always empty and flush the tank after each use; never
leave chemicals in tank for extended periods
• Inspect spray hose and electric
cord for wear or damage.
• Protect nozzle when not in use.
• Cean the filters on the bottom
plate of the fogger; be certain to
replace (this protects the motor).
Before Starting
Trouble Shooting
Operating Instructions
Very Important
2600, 2400, 2300 FOGGERS
USER’S MANUAL
Problem:
Fog and power mist is weak
Solution: •
Tighten the cap
Problem:
Liquid forms around the base of the motor
housing, around mounting screws
Solution: •
Unit may have been operating too long and fog
droplets in the ar are forming on the metal
screws
Problem:
Fogger is operating erratially; frequently turning
on and off
Solution:
• Inspect the electric cord and the plug for dam-
age
• Motor may be damaged from moisture, replace
motor
Problem:
Fogger becomes very warm (hot) during normal
operation
Solution: •
Remove the lower plate (motor guard) and clean
the filters with a nylon brush
• Connect unit to the designated electrical supply:
Do not connect 110V units to 220V power,
Do not connect 220V units to 110V
power.
• Do not move or position the fogger
by pulling it by the electric cord.
• Always use a grounded (3 terminal)
extension cord.
• Adjustment knob open one-quarter to one-half turn - This
delivers a ULV fog.
• The spray can not be seen because
the droplets are very small.
• Adjustment knob open one full turn -
This delivers a power mist which is
visible from nozzle.
• Calibrate the adjustment knob:
• Turn the knob until closed
• Push down on base of knob and align
the point with groove on the nozzle
• Release base to set the point
• Push down and turn the base, align
with groove
• When fogging is finished and the unit will be turned
off, follow this sequence:
First, turn off adjustment knob
Second, turn off electric power
Third, open the tank cap
Turn off the
adjustment knob
before turning
power off
Note:
Failure to
follow this sequence
can result in liquid
insecticide dripping into the hose and
eventually reaching and destroying the motor.
Care and Maintenance
2400, 2600 Operation
Filling
• Do not add more than 1.5 gallons (5.5 liters) liquid to the
tank.
• Do not mix chemical in the tank; pre-mix and then add to
the tank.
• Mix all chemicals according to label directions.
Placement During Operation
• Never place fogger directly on floor, always elevate to keep
dust and moisture out of fogger
• Do not operate fogger in enclosed or small areas for more
than 30 minutes.
Safety Precautions
95138800 Rev 2/10
Clean filter
regularly
