1.1 installation safety warnings
WARNING!
Crush injury from
unsecured door
• Place a 2 metre exclusion zone around area under the garage opening
while installing door. If sufficient area is not available DO NOT install door.
• Follow the installation instructions.
Tension Springs
• FRAME ONLY DOORS require spring tensioning AFTER the cladding is installed.
DO NOT operate the door without tensioning the springs.
• Ensure correctly fitting winding bar is used.
• Ensure the correct length winding bar is utilised.
• Ensure winding bar is placed appropriately in the torsion socket plug.
• Ensure correct bolts are tightened or loosened (or clamp pliers) to ensure
there is no release or controlled release of energy from the spring either
through the torsion bar or the winding bar.
• Keep hands clear of the torsion plug at all times.
• Keep head clear of the tensioning bar at all times.
ELECTROCUTION!
• Check risk assessment for any highlighted electrical power concerns.
• Ensure power source is isolated prior to commencement of job.
• Turn off electricity to site when necessary.
• Ensure you check the substrate for electrical wiring prior to penetration.
• Wear rubber soled footwear.
LACERATION:
• Wear appropriate PPE (Dyneema cut off gloves) and keep hands well clear
of pinch points.
• Follow instructions explicitly, particularly for the installation of some parts
of the panel doors, as the unrolled cut out edges presents a very sharp
edge.
CAUTION:
Muscular strain
• Practice correct lifting techniques when required.
• Use mechanical aids such as lifting devices, forklift and cranes where
possible.
• Avoid twisting.
Fall from ladder
• Ensure ladder is the correct type for job.
• Ensure ladder is on flat firm ground that will take the weight without the legs
sinking.
• Ensure user has 3 points of contact while on ladder.
Hand Tools
• Wear appropriate PPE and utilise operators manual of all tools.
• Use appropriate noise/hearing protection in the form of ear plugs or ear
muffs.
• Ensure appropriate fire protection available and housekeeping to ensure
that flammable liquids or materials are removed from the area of work.
Entanglement
• Keep hands and loose clothing clear of moving door and guides at all
times.
TWO PERSON LIFT:
• Depending on the size of the door, this product may requires a two person
lift. Use proper techniques and equipment to lift the door from the trailer
and into position.
This B&D Door is designed and tested to provide security, attractive appearance and smooth , low
effort operation provided it is installed and operated in strict accordance with the following safety
warnings. Failure to comply with the following instructions may result in death, serious personal injury
or property damage.
NOTE:
No guarantee will be given or responsibility accepted by the manufacturers if the door is not
installed as instructed.
1.0 before you begin
3
The Designer Series
&
P7 Industrial
™
installation instructions
