3. Check all painted surfaces for bare metal (matching paint is available from the manufacturer.)
(a) If bare metal is showing, paint with primer or solvent-based paint.
(b) If rust appears, remove it with sand paper or chemical means. Then paint with primer
or solvent-based paint.
4. Clean steam filter, where applicable. See figure 6.4.
5. Remove back panel and check overflow hose and drain hose for leaks.
6. Remove top cover and check the supply dispenser hoses and hose connections.
7. Clean inlet hose filter screen:
(a) Turn water off and allow valve to cool, if necessary.
(b) Unscrew inlet hose and remove filter screen.
(c) Clean with compressed air and reinstall. Replace if worn or damage.
8. Tighten motor mounting bolts and bearing housing bolts, if necessary.
9. Use compressed air to clean lint from motor.
10. Clean external water and steam filters
Figure 6.4: Steam Trap Service
6.5
Care of Stainless Steel
Maintain the natural beauty of stainless steel and prolong its service life by following these steps.
42
Summary of Contents for HE-110
