Important Safety Information
SAFETY CHECK LIST
Before Initial start up of a B&C washer –
extractor perform the following safety check:
A.
Make sure all electrical and plumbing
connections have been made in accordance
with applicable codes and regulations.
B.
Make sure the machine is
grounded electrically.
C.
Make sure the machine has
flexible water fill and drain connections of the
correct size, length and type, with no kinks, and
that they are securely attached and/or clamped.
D.
Make sure any transport brackets have
been removed.
Before servicing any equipment, make certain it
is disconnected from the electrical power
source. Never allow operation of the machine
when any safety device is malfunctioning.
Never bypass safety devices.
6
Before machine is placed in operation, the door
safety interlock must be checked for proper
operation as follows:
A.
When the washer is energized
electrically and in operation, the loading door
must be locked in the closed position. Verify
this by attempting to open the loading
door when the machine is operating. If
necessary, check the door safety interlock and
sensors for proper operation. Consult the
service manual, or call a qualified service
technician if necessary.
B.
When the washers loading door is open,
it should not be possible to start the machine.
Verify this by attempting to start the washer
with the door open. Also, close the door
without locking it and verify that it is not
possible to start the machine with the door not
locked. If necessary, check the door lock
sensors for proper operation. Consult the
service manual, or call a qualified service
technician. If additional information is required,
contact your local distributor or call the
manufacturer of the machine.
Summary of Contents for FM7
Page 2: ......
