Operator’s Manual
20
Troubleshooting (Cont)
Buttons Do Not Light
1. Enter test mode and go to the lamp test under “diagnostics”
2. Check each lamp. Each test should make its lamp blink.
3. If none of the lamps work, check that the control panel harness is
undamaged and is properly plugged in to the board.
4. If one or more lamps do not work, try replacing the bulbs. The switches are
snapped into their bezels from underneath the control panel. The bezels do not
need to be removed.
5. Twist and pull the switch assembly out from underneath the control panel.
Replace the bulb and perform the lamp test again. If the lamp is functioning snap
the switch assembly back up into the bezel.
6. If replacing the lamp does not correct the problem the trouble may lie in the
output driver on the board
You do not see the device on your Phones Bluetooth
1. Enter test mode and go to the audio adjustments under “diagnostics”
2. Check the bluetooth network name and ensure you are connecting to the correct
device.
3. If you still cannot see the device navigate to "Clear all bluetooth pairings" under
the same audio adjustements menu and this should clear any existing pairings to
allow you to try to connect again.
