Bancolini UNISCAN C6R, User Manual

Page: 22 / 385

1-4
Connecting Power (if required)
If your host does not provide power to the scanner, you will need an external power
connection to the scanner:
1. Connect the interface cable to the bottom of the scanner, as described in Installing
the Interface Cable on page 1-3.
2. Connect the other end of the interface cable to the host (refer to your host manual
to locate the correct port).
3. Plug the power supply into the power jack on the interface cable. Plug the other
end of the power supply into an AC outlet.
Configuring Your Scanner
Two methods are available to configure your scanner: using the bar codes included in this
manual, or the 123Scan
configuration program.
Refer to Chapter 4, User Preferences for information about programming your scanner
using bar code menus. Refer to Chapter 11, 123Scan to configure your scanner using this
configuration program. A helpfile is available in the program.
The scanner supports RS-232, IBM 468X/469X, Keyboard Wedge, Wand Emulation,
Undecoded Scanner Emulation, USB, and Synapse to interface to a host system. Each
host specific chapter describes how to set up each of these connections.