baltur TBML 160 PN, Manual Instructions For Use

Page: 45 / 76

7 / 36
0006081428_201406
ENGLISH The working ranges are obtained from test boilers corresponding
to the standard EN267 and are indicative of the combination
burner-boiler. For correct working of the burner the size of the
combustion chamber must correspond to current regulations; if
not the manufacturers must be consulted.
OPERATING RANGE
BURNER CONNECTION
TO THE BOILER
ASSEMBLING THE HEAD UNIT
• Adjust the position of connector flange 5 by loosening the
screws 6 so that the combustion head penetrates the advised
amount into the combustion chamber as recommended by the
generator manufacturer.
• Fit the rigid pipe in the housing provided on the connection flange
and fasten it with the screw. This pipe will be cut flush with the
diffuser (see 0002934670).
• Position insulating seal 3 on the sleeve, placing cord 2 between
the flange and the seal.
• Fasten the Combustion Head unit 4 to the boiler 1 by means of
the stud bolts, washers and the nuts provided 7.
! Completely seal the space between the burner
sleeve and the hole in the refractory material
inside the boiler door with suitable material.
Thermal power of methane gas
Thermal power of diesel oil