baltur TBG 45 P, Instruction Manual

Page: 51 / 72

DESCRIPTION OF TBG 45P - 60P OPERATION
When the main switch and the I/O switch START/STOP switch on the
electrical panel are on, if the thermostats are on, voltage will reach
the command and control device, which starts up the burner (led 7
switches on).
This turns on the fan motor for pre-ventilation of the combustion
chamber. At the same time, the servomotor commanding the air lock
opens in the position corresponding to the second flame, so pre-
ventilation takes place with the air lock in the second flame position.
At the end of the pre-ventilation phase, the air lock is returned to the
first flame position, then the ignition transformer comes on and, 2
seconds later, the gas valves open.
The main valve, which has two stages, has a device for adjusting gas
delivery for the first and second flame.
The air damper is operated by a specific electric servomotor (see
SERVOMOTOR ADJUSTMENT CAMS). Keep in mind that when the
burner is locked out because the thermostat is tripped, the servomotor
returns the air lock to the closed position. The presence of the flame,
detected by the control device, permits continuation and completion
of ignition, turning off the ignition transformer. The second flame then
comes on (combustion air is increased and the second stage of the
main valve opens).
If there is no flame, the appliance shuts down in "safety lock-out"
mode (led 8 switches on) within 3 seconds of the opening of the first
flame on the main valve.
In “safety lock-out” mode the valves are closed again immediately.
To release the appliance from safety lock-out mode, press button
Reset button on the electrical panel.
0002935620
2
8 7
1
5
10
6
9
4
3
15 / 34
0006160178_202211
ENGLISH